Title: FORMATION OF SOL-GEL CATALYTIC COATINGS TO IMPROVE THE ECOLOGICAL PARAMETERS OF INTERMETALLIC POROUS BURNERS
Abstract: Экологические параметры энергетического оборудования важны с точки зрения минимизации негативного воздействия на окружающую среду. Интерметаллидные инфракрасные пористые беспламенные горелки являются новым поколением горелочных устройств с улучшенными характеристиками. Газовые горелки относятся к наиболее эффективным устройствам прямого преобразования теплоты горения в энергию инфракрасного излучения. Несмотря на улучшенные по сравнению с традиционными горелками экологические характеристики инфракрасных пористых горелок, при работе они могут выделять нежелательные и опасные продукты горения газовых смесей (или других топлив), особенно при переходных и высокомощных режимах. В этой работе были получены каталитические покрытия оксидных систем на основе церия с небольшим добавлением оксидов кремния. Осаждение каталитического материала на пористые интерметаллидные подложки фиксировалось с применением весового метода, оптической системы анализа и сканирующей электронной микроскопии, а изучение химической структуры - с помощью ИК-спектроскопии. Выявлено равномерное распределение покрытия по поверхности подложки и соответствие ИК-пиков химическому составу синтезированных систем. The environmental parameters of power equipment are important in terms of minimizing the negative impact on the environment. Intermetallic infrared porous flameless burners are a new generation of burners with improved performance. Gas burners are among the most efficient devices for direct conversion of combustion heat into infrared energy. Despite the improved environmental characteristics of infrared porous burners compared to traditional burners, during operation they can emit unwanted and hazardous combustion products of gas mixtures (or other fuels), especially during transient and high-power modes. In this work, catalytic coatings based on cerium-based oxide systems with a small addition of silicon oxides were obtained. The deposition of the catalytic material on porous intermetallic substrates was controlled using the gravimetric method, optical analysis system, and scanning electron microscopy, and its chemical structure was investigated using IR spectroscopy. The uniform distribution of the coating over the substrate surface and the correspondence of the IR peaks with the chemical composition of the synthesized systems were detected.