Title: 3D printing of high-strength aluminium alloys
Abstract: Zirconium nanoparticles introduced into aluminium alloy powders control solidification during 3D printing, enabling the production of crack-free materials with strengths comparable to the corresponding wrought material. 3D printing, or additive manufacturing, of metals uses a direct energy source, such as a laser or electron beam, to alloy powders, but has succeeded for only a few metals. Often, large columnar grains and cracks are generated during the solidification stage. In this paper, John Martin et al. confront this problem for aerospace-grade aluminium alloys that could not previously be 3D-printed. They decorate the metal powder feedstock with grain-refining nanoparticles that target each alloy. The composition of these nanoparticles was computed by identifying matching crystallographic lattice spacing and density to provide a low-energy nucleation barrier. During solidification, these nucleants generated small equiaxed grains which more easily accommodated the stresses generated during solidification, reducing the likelihood of cracks forming. The mechanical properties of the resulting structures were superior to those achieved without the grain refiners and comparable to those of wrought metal. Metal-based additive manufacturing, or three-dimensional (3D) printing, is a potentially disruptive technology across multiple industries, including the aerospace, biomedical and automotive industries. Building up metal components layer by layer increases design freedom and manufacturing flexibility, thereby enabling complex geometries, increased product customization and shorter time to market, while eliminating traditional economy-of-scale constraints. However, currently only a few alloys, the most relevant being AlSi10Mg, TiAl6V4, CoCr and Inconel 718, can be reliably printed1,2; the vast majority of the more than 5,500 alloys in use today cannot be additively manufactured because the melting and solidification dynamics during the printing process lead to intolerable microstructures with large columnar grains and periodic cracks3,4,5. Here we demonstrate that these issues can be resolved by introducing nanoparticles of nucleants that control solidification during additive manufacturing. We selected the nucleants on the basis of crystallographic information and assembled them onto 7075 and 6061 series aluminium alloy powders. After functionalization with the nucleants, we found that these high-strength aluminium alloys, which were previously incompatible with additive manufacturing, could be processed successfully using selective laser melting. Crack-free, equiaxed (that is, with grains roughly equal in length, width and height), fine-grained microstructures were achieved, resulting in material strengths comparable to that of wrought material. Our approach to metal-based additive manufacturing is applicable to a wide range of alloys and can be implemented using a range of additive machines. It thus provides a foundation for broad industrial applicability, including where electron-beam melting or directed-energy-deposition techniques are used instead of selective laser melting, and will enable additive manufacturing of other alloy systems, such as non-weldable nickel superalloys and intermetallics. Furthermore, this technology could be used in conventional processing such as in joining, casting and injection moulding, in which solidification cracking and hot tearing are also common issues.