Title: Effective passivation of the low resistivity silicon surface by a rapid thermal oxide/PECVD silicon nitride stack and its application to passivated rear and bifacial Si solar cells
Abstract: A novel stack passivation scheme, in which plasma silicon nitride (SiN) is stacked on top of a rapid thermal SiO{sub 2} (RTO) layer, is developed to attain a surface recombination velocity (S) approaching 10 cm/s at the 1.3 {Omega}-cm p-type (100) silicon surface. Such low S is achieved by the stack even when the RTO and SiN films individually yield considerably poorer surface passivation. Critical to achieving low S by the stack is the use of a short, moderate temperature anneal (in this study 730 C for 30 seconds) after film growth and deposition. This anneal is believed to enhance the release and delivery of atomic hydrogen from the SiN film to the Si-SiO{sub 2} interface, thereby reducing the density of interface traps at the surface. Compatibility with this post-deposition anneal makes the stack passivation scheme attractive for cost-effective solar cell production since a similar anneal is required to fire screen-printed contacts. Application of the stack to passivated rear screen-printed solar cells has resulted in V{sub oc}`s of 641 mV and 633 mV on 0.65 {Omega}-cm and 1.3 {Omega}-cm FZ Si substrates, respectively. These V{sub oc} values are roughly 20 mV higher than for cells with untreated, highly recombinative back surfaces. The stack passivation has also been used to form fully screen-printed bifacial solar cells which exhibit rear-illuminated efficiency as high as 11.6% with a single layer AR coating.